Carbon Fiber Pultruded Flat Bar 0.070 X 0.437 X 96 Inches Made in USA

Description

Carbon Fiber Pultruded Flat Bar 0.070 X 0.437 X 96 Inches. Black in color made in USA
Each 96 inch piece weighs slightly less than 3 ounces.
The CarbonFiber stock mentioned in this listing was part of the inventory purchased to manufactured48 custom drone light frames. The smaller frames are seen here.
These drones were built for the Grand Openingof the Baha Mar Resort and Casino in the Bahama Islands using this same highquality American made carbon fiber.
Pultruded
- Carbon Fiber manufactured from continuous carbon fibers in an vinylester base. Material is extremely stiff and lightweight and has a very low coefficient of expansion. One side of the laminate has been purposely roughened to facilitate bonding to the surface. If bonding on both sides is required, the smooth side should be roughened up with sandpaper.
Resin Type:  Vinyl Ester.
Fiber Type:  33 m.s.i. Carbon.
Unidirectional Orientation.  390,000
PSI Tensile, 272,000 PSI
Flexural Strength,
.057 lb/in3 Density
Stiffness: 50-200 GPA
Thermal Expansion: 1 to 5 ppm/C
Fracture Toughness:  10-15 MPa-m1/
PAYPAL ONLY